ABSTRACT
The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system.
The project construction of automatic fence light controller has been done primarily as a photo type design it could be further modified suit the situation where it will be used e.g when used to activate an alarm the led could be further modified to suit the situation where it will be used e.g when used to activate an alarm the led could be replaced with a relay and feedback resistor removed (for greater sensitivity)
TABLE OF CONTENTS
Title page
Approval
Abstract
Table of contents
Acknowledgement
CHAPTER ONE
1.1Introduction
CHAPTER TWO
2.1 Description of components used
2.2 Integrated
2.3 Transistor
2.4 Diode
2.5 Resistor
2.6 Variable resistor (preset)
2.7 Capacitor
2.8 Light dependent resistor (LDR)
2.9 Relay
2.10 Transformer
CHAPTER THREE
3.1Circuit drawing of the automatic fence light controller
3.2Achieve function of the alto fence light controller
3.3Rectification stage of the circuit
CHAPTER FOUR
4.1Principles of operation of the automatic fence light controller
4.2Project component /materials cost & packaging
CHAPTER FIVE
5.1Test measurement and observation
5.2Conclusion and recommendation
5.3References.
