STUDY OF HYDRAULIC JUMP IN A RECTANGULAR FLUME BY COMPARING RECTANGULAR BLOCK WIER AND SLUICE GATE

  • Type: Project
  • Department: Civil Engineering
  • Project ID: CVE0220
  • Access Fee: ₦5,000 ($14)
  • Pages: 60 Pages
  • Format: Microsoft Word
  • Views: 454
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

This experiment was conducted in order to have a broader knowledge on hydraulic jump and its 

applications. It was performed in the hydraulic laboratory of the department of Water Resources 

and Environmental Engineering, Ahmadu Bello University, Zaria, using the TQH23, 2.52m flow 

rectangular channel and the HID hydraulic bench which provides water to the channel with the 

aid of the pump incorporated in the HID.

Five different discharges were obtained by varying the flow. Hydraulic jump was formed at four 

different positions for each of the discharge using both rectangular block weir and sluice gate 

while maintaining the same discharge.

Based on the results obtained and calculated from the experiment after comparing rectangular 

block weir and the sluice gat, it was observed that when using the rectangular block weir that 

discharges shows an oscillating jump type since the value of their 

Froude’s number, ratio of depth after and before the jump and fraction of energy dissipated 

falls within the range of the characteristics of hydraulic jump, also from fig 4.3 shows that at a 

height of 0.035m, 0.037m and 0.038m of the downstream sequent depth will dissipate excess 

energy compare to sluice gate.

Also, for sluice gate, discharge = 0.556× 

/s with = 3.74, = 3.33 and 

fraction of energy dissipated = 44.83% formed an oscillating jump which it value of Froude’s 

number, ratio of depth after and before the jump and fraction of energy dissipated fall within the

range of the characteristics of hydraulic jump. And also discharge = 0.625× 

/s with 

 =6.29, = 6.03 and fraction of energy dissipated = 66.67% formed a stable clearly 

defined well balanced which it value of Froude’s number, ratio of depth after and before the 

jump and fraction of energy dissipated fall within the range of the characteristics of hydraulic 

jump. While the remaining discharges and are out of range that means there values 

did not fall within the range of the characteristics of hydraulic jump of table 2.2. and also fig 4.3 

shows that at a height of 0.041m of downstream sequent depth will dissipate excess energy

compared to rectangular block weir.

STUDY OF HYDRAULIC JUMP IN A RECTANGULAR FLUME BY COMPARING RECTANGULAR BLOCK WIER AND SLUICE GATE
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Civil Engineering
  • Project ID: CVE0220
  • Access Fee: ₦5,000 ($14)
  • Pages: 60 Pages
  • Format: Microsoft Word
  • Views: 454
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

500
Leave a comment...

    Details

    Type Project
    Department Civil Engineering
    Project ID CVE0220
    Fee ₦5,000 ($14)
    No of Pages 60 Pages
    Format Microsoft Word

    Related Works

    ABSTRACT  This study on the integrated solar and hydraulic jump enhanced waste stabilization pond (ISHJEWSP) is aimed at determining the effect of variations in solar radiation, hydraulic jump, hydro-kinematic factors and pond geometry, on the treatment efficiency of wastewater in the ISHJEWSP. An equation to account for these effects was... Continue Reading
    Studies have been done on the aspect ratio effect on natural convection turbulence using standard  k-ε model but further studies showed that k-ω SST model performed better than both k-ε and k-ω  model in the whole enclosure. Thus, there was need to do a numerical study on the natural  convection fluid flow in a rectangular enclosure full of... Continue Reading
    ABSTRACT Turbulent flow is a type of fluid flow in which the fluid undergoes irregular fluctuations. The velocity of the fluid at a point is continuously undergoing changes in both magnitude and direction. Turbulent natural convection has been studied both numerically and theoretically. It plays an important role in the field of heat transfer and... Continue Reading
    ABSTRACT The purpose of this work is to use the energy approach in the form of direct variational principle (Rayleigh-Ritz method) for buckling analysis of thin rectangular plates with various boundary conditions using Taylor series shape functions. To do this, thin rectangular flat plate of various boundary conditions with three dimensions Ly, Lx... Continue Reading
    ABSTRACT The purpose of this work is to use the energy approach in the form of direct variational principle (Rayleigh-Ritz method) for buckling analysis of thin rectangular plates with various boundary conditions using Taylor series shape functions. To do this, thin rectangular flat plate of various boundary conditions with three dimensions Ly, Lx... Continue Reading
    Abstract -. 'Since. statisticians do not usually perform an experiment, their claim to attention when they write on experimentation requires some explanations', William Cochran and Gertrude Cox (1957). Block designs are widely used in many fields of research. Their most common type is the randomized (complete) block design. It is not applicable... Continue Reading
    The present research discusses a problem of seal damages in dam gates due to  influence of water flow through sluices passage way. The low level sluices (L.L.S) of  Merowe dam were taken as a research field to investigate the influence of flow on the  gate seal. The core of the problem is that the rubbery seal of L.L.S gates is damaged  and... Continue Reading
    ABSTRACT Aquifer Hydraulic Characteristics and Vulnerability Estimation from Vertical Electrical Sounding: A Case Study of Oru and its Environs, South-Eastern, Nigeria was carried out to delineate the different aquifer units with a view to determine the vulnerability of groundwater in the area. The study area is underlain by the Benin Formation... Continue Reading
    Abstract Hydraulic fracturing is an effective well stimulation technique which is introduced in the 1950s and widely used in the oil and gas industry. Most of the works about hydraulic fracture assumed that the fracture is symmetric and either vertical or horizontal. But, several field and laboratory observations show very complex fractures,... Continue Reading
    ABSTRACT This study examined the challenges and prospects of tax administration in Minna, Nigeria using Mutunci Block Industry as a case study. Three research questions were formulated to guide the study. The research design adopted for the study was a descriptive survey design. The sample of the study constituted of 20 respondents. A... Continue Reading
    Call Us
    whatsappWhatsApp Us