DESIGN AND INSTALLATION OF AN AUTO-SOLAR POWERED SYSTEM

  • Type: Project
  • Department: Computer Science
  • Project ID: CPU1877
  • Access Fee: ₦5,000 ($14)
  • Pages: 52 Pages
  • Format: Microsoft Word
  • Views: 604
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

ABSTRACT
Researchers suggest that the amount of sunlight that strikes the Earth's surface in an hour and a half is enough to handle the entire world's energy consumption for a full year. Solar power system is one of the best renewable energy technologies which is not only cost effective but environment friendly as well.This study aimed at designing and installing a quite low-cost inverter of 3.5KVA with high efficiency and quality output capabilities to power some appliances of a total load not more than 3.5KVA in the department of Computer Science, Heritage Polytechnic, Ikot Udota, Eket. A standard procedure for the design was developed. The standard procedure developed was validated in the design of the 3.5KVA off grid-connected solar photovoltaic (PV) system. An extensive literature review of solar PV systems with a special focus on off grid-connected systems was conducted after which the procedure for the design of institutional small-scale off grid connected solar PV systems was developed. For this research, we have suggested methodologies that may be applicable to other off grid applications. Off-grid or standalone systems can be defined as independent systems that are not connected to any electrical grid. These come in different sizes and are mostly used in location where there is little access to grid infrastructure. A battery backup has been installed as a continuous power supply in case of an overcast day. The system is designed in such a way that it will take up 12V direct current (DC) from the charge controller and inverts it to an output of 220V, 50Hz alternating current (AC). The circuit is capable of charging the battery when power from supply authority (Port Harcourt Electricity Distribution - PHED) is on and also when sun rays heat the solar panel. This greatly reduces the cost of operation of the system.The preliminary testing results showed that the project is socially beneficial to the department. The process of electricity generation from solar PV saves large tonnes of CO2. The project will help reduce the dependency of grid and allow the department to operate in self-sufficient manners without reliance on one or more public utilities.

DESIGN AND INSTALLATION OF AN AUTO-SOLAR POWERED SYSTEM
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Computer Science
  • Project ID: CPU1877
  • Access Fee: ₦5,000 ($14)
  • Pages: 52 Pages
  • Format: Microsoft Word
  • Views: 604
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

500
Leave a comment...

    Details

    Type Project
    Department Computer Science
    Project ID CPU1877
    Fee ₦5,000 ($14)
    No of Pages 52 Pages
    Format Microsoft Word

    Related Works

    ABSTRACT Researchers suggest that the amount of sunlight that strikes the Earth's surface in an hour and a half is enough to handle the entire world's energy consumption for a full year. Solar power system is one of the best renewable energy technologies which is not only cost effective but environment friendly as well.This study aimed at... Continue Reading
    ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading
    ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading
    ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller.... Continue Reading
    Abstract In this project we designed a solar powered computer control system  for electrical machines and spark ignition engines. It is made up of a  hardware device that comprises of various electrical components  which are powered by a 25W solar panel. The power cord of the  machines are modified and connected to the hardware and the ... Continue Reading
    Abstract In this project we designed a solar powered computer control system  for electrical machines and spark ignition engines. It is made up of a  hardware device that comprises of various electrical components  which are powered by a 25W solar panel. The power cord of the  machines are modified and connected to the hardware and the ... Continue Reading
    ABSTRACT Automatic gate is one of most usefully thing to use in companies, colonies, collages, homes, and schools. There is some type to operate a gate such as a sliding on screw or on rack and pinion, piston operated, rotary. Design is available for some type of operation and it is most costly also When installation and maintenance cost is not... Continue Reading
    ABSTRACT Cell phones need electric sources to charge their batteries in order to work, but there are people in developing and third world countries that find it hard to access electric sources.In an attempt to provide an alternative means of charging to those unfortunate areas in third world and developing countries, a solar powered cell phone... Continue Reading
    Abstract More than 2.2 million Ghanaian families in rural areas depend on firewood and charcoal as fuel for cooking [1]. This high dependency is taking a toll on forest resources due to rampant deforestation. “Ghana's forest cover, which stood at 8.2 million hectares in 1900, has now been reduced to about 1.2 million hectares, with an estimated... Continue Reading
    ABSTRACT Cell phones need electric sources to charge their batteries in order to work, but there are people in developing and third world countries that find it hard to access electric sources.In an attempt to provide an alternative means of charging to those unfortunate areas in third world and developing countries, a solar powered cellphone... Continue Reading
    Call Us
    whatsappWhatsApp Us