DESIGN AND IMPLEMENTATION OF AUTOMATIC SECURITY LIGHTING SYSTEM FOR ATBU YELWA CAMPUS.

  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0378
  • Access Fee: ₦5,000 ($14)
  • Pages: 36 Pages
  • Format: Microsoft Word
  • Views: 395
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

ABSTRACT

This project work has covered the design of an automatic security lighting system for ATBU, Yelwa Campus. Requirements for illuminance, type of fittings, power dissipation and mounting height were put into consideration. An electronic model of the campus was built with the streets outlined and lamps fixed at positions along the streets according to the design. An electronic control, based on a Light Dependent Resistor (LDR) is built, which provides automatic switch on and switch off of the system at dusk and dawn respectively. A delay is incorporated so that the circuit does not responds to small changes in illumination and any momentary brightness the transducers may sense and power requirements for the system is evaluated.

TABLE OF CONTENTS

Contents                                                                                                                 

Title page

Declaration                                                                                                                  

Certification                                                                                                                

Dedication                                                                                                                  

Acknowledgement                                                                                                      

Abstract                                                                                                                      

Table of content                                                                                                           

Reference                                                                                                                   

List of Figure                                                                                                             

List of Tables                                                                                                              


CHAPTER ONE

1.0     INTRODUCTION                                                                                              

1.1 Background Information                                                                                         

1.2 Aim and Objectives                                                                                               

1.3 Problem Statement                                                                                               

1.4 Scope of work                                                                                                       

1.5 Motivation                                                                                                            


CHAPTER TWO

2.0 LITERATURE REVIEW AND THEORETICAL BACKGROUND                 

2.1 Introduction                                                                                                          

2.2 Review of past work                                                                                             

2.3 Improvement of past work                                                                                    


CHAPTER THREE

3.0 ANALYSIS, DESIGN AND IMPLEMENTATION                                             

3.1 Theoretical background and analysis                                                                    

3.1.1 System block diagram of an automatic security lighting system for ATBU, Bauchi Yelwa Campus                                            

3.1.2 Power Supply unit design                                                                                   

3.1.3 Transformer section                                                                                            

3.1.4 Voltage regulation section                                                                                   

3.1.5 Sensor unit design                                                                                               

3.1.6 Reference input                                                                                                   

3.1.7 Comparator unit design                                                                                       

3.1.8 Delay unit design                                                                                                 

3.1.9 Switching unit design                                                                                           

 3.1.10 Lighting unit                                                                                                      


CHAPTER FOUR

4.0 TEST, RESULTS AND DISCUSSION                                                                   

 4.1 Tests                                                                                                                         

 4.1.1 Test on power supply                                                                                            

 4.2 Results                                                                                                                      

4.3 Discussion                                                                                                                

 


CHAPTER FIVE

5.0 SUMMARY, CONCLUSION AND RECOMMENDATION                                  

5.1 Summary                                                                                                                   

5.2 Conclusion                                                                                                                 

5.3 Recommendation                                                                                                       

REFERENCES                                                                                                              

APPENDIX I:    Circuit diagram of an automatic security lighting system                    

APPENDIX II:   Side view of the soldered circuit                                                          

APPENDIX III:  Front view of the soldered circuit                                                         

APPENDIX IV: Model of the automatic security lighting system for ATBU, Bauchi Yelwa Campus.                                     

 


LIST OF FIGURES

Fig.1       Block diagram of the automatic security lighting system                                     

Fig.2        Power supply unit                                                                                                 

Fig.3        Circuit for the sensory unit and comparator unit                                                  

Fig.4        Circuit diagram for delay unit and switching unit                                           


LIST OF TABLES

 

Table 1:            current, voltage, power and cable sizes of zone I                                       

Table 2:           current, voltage, power and cable sizes of zone II                                     

Table 3:           current, voltage, power and cable sizes of zone III                                     

Table 4:            current, voltage, power and cable sizes of zone IV                                   

Table 5:            current, voltage, power and cable sizes of zone V 

 

 

DESIGN AND IMPLEMENTATION OF AUTOMATIC SECURITY LIGHTING SYSTEM FOR ATBU YELWA CAMPUS.
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0378
  • Access Fee: ₦5,000 ($14)
  • Pages: 36 Pages
  • Format: Microsoft Word
  • Views: 395
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

500
Leave a comment...

    Details

    Type Project
    Department Electrical Engineering
    Project ID ELE0378
    Fee ₦5,000 ($14)
    No of Pages 36 Pages
    Format Microsoft Word

    Related Works

    ABSTRACT This project work has covered the design of an automatic security lighting system for ATBU, Yelwa Campus. Requirements for illuminance, type of fittings, power dissipation and mounting height were put into consideration. An electronic model of the campus was built with the streets outlined and lamps fixed at positions along the streets... Continue Reading
    ABSTRACT This project work has covered the design of an automatic security lighting system for ATBU, Yelwa Campus. Requirements for illuminance, type of fittings, power dissipation and mounting height were put into consideration. An electronic model of the campus was built with the streets outlined and lamps fixed at positions along the streets... Continue Reading
    TABLE OF CONTENT DECLARATION.................................................................................................................................. i APPROVAL........................................................................................................................................ ii DEDICATION... Continue Reading
    ABSTRACT In this current situation, the degree of security is feeble. So there is a lot of robbery, theft going on in and around the world. So, people fear to keep any of their valuables in their homes. Henceforth, many people prefer to keep it in banks. However, in this insecure world even banks are not too safe enough to satisfy people needs. A... Continue Reading
    CHAPTER ONE INTRODUCTION 1.1 BACKGROUND OF THE STUDY Traditionally, high control in home and office environments takes place through switches (on/off), deals and sliders (dimmers) and sometimes motion sensors. These controls can be incorporated in the built environment such as walls, or attached to lights that people place themselves (desk lamps,... Continue Reading
      ABSTRACT Mobile phones are nowadays, far more than merely communication devices. In particular, Smartphones  and Tablets are  products  that  help  to  make  our  works  and  everyday  life  easier.  Along  with  the advance  in  technology  and  popularity  of  these  devices,  the  use  of  mobile  applications ... Continue Reading
      ABSTRACT Mobile phones are nowadays, far more than merely communication devices. In particular, Smartphones  and Tablets are  products  that  help  to  make  our  works  and  everyday  life  easier.  Along  with  the advance  in  technology  and  popularity  of  these  devices,  the  use  of  mobile  applications ... Continue Reading
    CHAPTER ONE INTRODUCTION 1.1      Background of the Study Elections form a critical process in democratic systems and application of information technologies to their management is a great milestone towards realizing effectiveness and efficiency not only in the results of the election process itself but also in the financial implications that... Continue Reading
    ABSTRACT Fire disaster is a great threat to lives and properties, and it accounts for over 70% of total loss of properties and about 20% of total loss of lives every year in Nigeria. Although some conventional fire preventive systems have been developed which are not enough to take prompt action during fire, save properties, and ultimately save... Continue Reading
    ABSTRACT  This report contains five chapters, in chapter one, as an introductory part of this project report, contained in chapter, we first define what accident is, the background of the study, that is to say, how the problem started or what prompted us to carry out the project. The problem statement, this is about the challenges we are solving,... Continue Reading
    Call Us
    whatsappWhatsApp Us