SPECTROPHOTOMETRIC DETERMINATION OF PARACETAMOL USING ZIRCONIUM (IV) OXIDE AND AMMONIUM TRIOXOVANADATE (V)

  • Type: Project
  • Department: Industrial Chemistry
  • Project ID: IDC0030
  • Access Fee: ₦5,000 ($14)
  • Pages: 82 Pages
  • Format: Microsoft Word
  • Views: 400
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

ABSTRACT

A simple and sensitive spectrophotometric method for the determination of paracetamol was explored, using zirconium(IV) and vanadium(V) oxides. The method was based on the oxidation of paracetamol by zirconium(IV) and vanadium(V) in alkaline and acidic media respectively. The stoichiometric studies indicated a mole-ratio of 1:1 for the reactions of paracetamol with both zirconium(IV) and vanadium(V). Effects of other variables like pH, temperature and time were determined and showed that the optimum conditions for the oxidation of paracetamol by zr(IV) were pH of 9.0, temperature of 50˚C and at 20 min yielding red- brown p-benzoquinone which absorbed at a λmax of 420 nm. Similarly, optimum conditions for the oxidation of paracetamol by V(V) were pH of 1.0, temperature of 70˚C at 8 min, and V(V) reduced to bluish-violet vanadium(II) ions which absorbed at a λmax of 600 nm. The Beer-Lambert’s law was obeyed at a concentration range of 5.0-40.0 μg/cm3 for paracetamol with both Zr(IV) and V(V) respectively; and the correlation coefficients for both oxidants were 0.997 and 0.999 respectively. The mean % recovery of paracetamol in dosage form with Zr(IV) was 99.06 %, while V(V) gave 100.17 %. Hence, the recovery studies had proved the method to be accurate, simple and precise.


TABLE OF CONTENTS

Title page --------------------------------------------------------------------- i

Certification------------------------------------------------------------------- ii

Dedication -------------------------------------------------------------------- iii

Acknowledgment ------------------------------------------------------------- iv

Table of Contents ----------------------------------------------------------- v

List of Tables ----------------------------------------------------------------- vi

List of Figures ---------------------------------------------------------------- vii

Abstract ---------------------------------------------------------------------- viii

CHAPTER ONE

1.0 Introduction ------------------------------------------------------------- 1

1.1 Ultraviolet – visible spectrophotometry (UV – visible spectrophotometry). ---------------------------------------------------- 1

1.2 Paracetamol ------------------------------------------------------------- 4

1.3 The structure of paracetamol ----------------------------------------- 5

1.4 Mechanism of action of paracetamol--------------------------------- 6

1.5 Metabolism -------------------------------------------------------------- 10

1.6 Medical uses of paracetamol ----------------------------------------- 10

1.7 Adverse effects/toxicity ------------------------------------------------ 11

1.8 Statement of the problem --------------------------------------------- 12

1.9 Objectives of the study ------------------------------------------------- 13

CHAPTER TWO:

2.0 Literature review -------------------------------------------------------- 14

2.1 A brief historical background of paracetamol---------------------- 14

2.2 Methods of determining paracetamol. ------------------------------- 17

2.2.1 Chromatographic methods of determination ------------------- 17

2.2.2 UV-Visible spectrophotometric methods ------------------------ 21

2.2.3 Fluorescence spectrometric methods ---------------------------- 27

2.3 Spectrophotometric determination of the stoichiometry of metal to ligand in a complex ----------------------------------------- 30

CHAPTER THREE

3.0 Materials and methods ------------------------------------------------ 33

3.1 Materials ----------------------------------------------------------------- 33

3.1.1 Aparatus/Equipment----------------------------------------------- 33

3.2.0 Preparation of Reagents ------------------------------------------- 33

3.2.1 Preparation of 0.1 M paracetamol -------------------------------- 33

3.2.2 Preparation of 0.1 M Zirconium(IV) oxide, (Zirconia) ---------- 33

3.2.3 Preparation of 0.1 M ammonium trioxovanadate(V) ----------- 34

3.3.0 Absorption spectra-------------------------------------------------- 35

3.3.1 Absorption spectrum of paracetamol ---------------------------- 35

3.3.2 Absorption spectrum of zirconium(IV) in sodium hydroxide Medium ----------------------------------------------------------------- 35

3.3.3. Absorption spectrum of mixture of paracetamol and Zr(IV) in sodium hydroxide medium------------------------------------- 36

3.3.4 Absorption spectrum of vanadium(V) in tetraoxosulphate(VI) acid medium --------------------------------- 36

3.3.5 Absorption spectrum of mixture of paracetamol and vanadium(V) in tetraoxosulphate(VI) acid medium------------- 36

3.4.0 Determination of the stoichimetry of the reactions between paracetamol and the oxidants -------------------------- 37

3.4.1 Stoichiometry of reaction between paracetamol and zirconium(IV) --------------------------------------------------------- 37

3.4.2 Stoichiometry of reaction between paracetamol and vanadium(V) ---------------------------------------------------------- 37

3.5.0 Determination of optimal conditions ----------------------------- 38

3.5.1 Effect of pH on Zr(IV)-paracetamol reaction ---------------------- 38

3.5.2 Effect of pH on V(V)-paracetamol reaction ---------------------- 38

3.5.3 Effect of time on the reaction of paracetamol with zirconium(IV) --------------------------------------------------------- 38

3.5.4 Effect of time on the reaction of paracetamol with V(V) ------- 39

3.5.4 Effect of temperature on the reaction paracetamol with Zirconium(IV) --------------------------------------------------------- 39

3.5.6 Effect of temperature on the reaction of paracetamol with vanadium(V) ---------------------------------------------------- 39

3.6.0 Beer’s calibration plots -------------------------------------------- 39

3.6.1 Calibration curve for paracetamol-Zr(IV) reaction ------------- 39

3.6.2 Calibration curve for paracetamol-V(V) reaction --------------- 40

3.7.0 Quantitative assay of the drugs----------------------------------- 40

3.7.1 Assay of paracetamol with Zirconium(IV) ----------------------- 40

3.7.2 Assay of paracetamol with vanadium(V)------------------------- 41

CHAPTER FOUR

4.0 Results and discussion----------------------------------------------- 42

4.1 Absorption spectrum of paracetamol. ------------------------------ 42

4.2 Absorption spectrum of zirconium(IV) in NaOH medium.------- 42

4.3 Absorption spectrum of a mixture of paracetamol and zirconium(IV) in NaOH medium ------------------------------------ 42

4.4 Absorption spectrum of vanadium(V) in tetraoxosulphate(VI) acid medium ------------------------------- 47

4.5 Absorption spectrum of the product of paracetamol-V(V) reaction in H2SO4 medium ------------------------------------------- 47

4.6.1 Stoichiometry of reaction between paracetamol and Zr(IV)--- 49

4.6.2 Stoichiometry of reaction between paracetamol and vanadium(V) ---------------------------------------------------------- 50

4.7.0 Effect of pH on the reaction of paracetamol and Zr(IV) ------- 51

4.7.1 Effect of pH on paracetamol-V(V) reaction ---------------------- 52

4.7.2 Effect of time on the reaction of paracetamol with Zr(IV) ----- 53

4.7.3 Effect of time in the reaction of paracetamol with vanadium(V) ---------------------------------------------------------- 54

4.7.4 Effect of temperature on paracetamol-Zr(IV) reaction --------- 55

4.7.5 Effect of temperature on paracetamol-vanadium(V) reaction 56

4.8 Beer’s calibration plot for the reaction of paracetamol with zirconium(IV)------------------------------------------------------ 57

4.8.2 Beer’s calibration plot for the reaction of paracetamol with vanadium(V) ----------------------------------------------------- 58

4.9.0 Validation of paracetamol in dosage form with zirconium(IV)-59

4.9.1 Validation of paracetamol in dosage with vanadium(V) ------- 60

CHAPTER FIVE

Conclusion-------------------------------------------------------------------- 61

References -------------------------------------------------------------------- 62

SPECTROPHOTOMETRIC DETERMINATION OF PARACETAMOL USING ZIRCONIUM (IV) OXIDE AND AMMONIUM TRIOXOVANADATE (V)
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Industrial Chemistry
  • Project ID: IDC0030
  • Access Fee: ₦5,000 ($14)
  • Pages: 82 Pages
  • Format: Microsoft Word
  • Views: 400
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

500
Leave a comment...

    Details

    Type Project
    Department Industrial Chemistry
    Project ID IDC0030
    Fee ₦5,000 ($14)
    No of Pages 82 Pages
    Format Microsoft Word

    Related Works

    ABSTRACT A simple and sensitive spectrophotometric method for the determination of paracetamol was explored, using zirconium(IV) and vanadium(V) oxides. The method was based on the oxidation of paracetamol by zirconium(IV) and vanadium(V) in alkaline and acidic media respectively. The stoichiometric studies indicated a mole-ratio of 1:1 for the... Continue Reading
    ABSTRACT The concentrations of some trace metals (zinc, iron, copper, cadmium and lead) in 51 canned foods (fish, vegetable and fruit juice) samples purchased within Abuja Municipal Area Council (Nigeria) were determined using the flame atomic absorption spectrophotometry (FAAS). The wet oxidation procedure of HN03-H20 2 was used in the... Continue Reading
    ABSTRACT The Schiff base ligand, 2-[(E)-[{3--[(2-hydroxybenzylidene)amino]phenyl}imino)methyl]phenol was synthesized by condensing 1,3-diaminobenzene and 2-hydroxybenzaldehyde in absolute ethanol. Its Cr(III) and Cr(VI) complexes were equally synthesized. The ligand was characterized via UV, IR and NMR spectroscopy, whereas the complexes were... Continue Reading
    ABSTRACT Starch is a naturally occurring polymer found in parts of the plants such as leaves, stems, tubers, and fruits. It is a commonly used excipient in pharmaceutical formulations because of its availability, affordability and inertness. Cyperus esculentus (tiger nut) is widely cultivated in the country especially in the northern part of... Continue Reading
    ABSTRACT It is proposed to design a process plant that will control nitrogen oxide emission from a plant that is producing 90wt% nitric acid of 30,000 tonnes of nitric acid. This capacity is based on 8000hours of operation per year i.e. 330 days. It is proposed that this plant will be located in any location where there is substantial release of... Continue Reading
    ABSTRACT It is proposed to design a process plant that will control nitrogen oxide emission from a plant that is producing 90wt% nitric acid of 30,000 tonnes of nitric acid. This capacity is based on 8000hours of operation per year i.e. 330 days. It is proposed that this plant will be located in any location where there is substantial release of... Continue Reading
    CHAPTER ONE 1.0 INTRODUCTION During the last decade worldwide concern with global climate has highlighted the challenge faced by both industrialized and developing countries in maintaining a sustained process of development. Nigeria, like other developing countries, shares the need for fast economic growth given the current low standard of living... Continue Reading
    ABSTRACT Zinc Oxide (ZnO) nanowires with hexagonal structure were successfully synthesized by chemical bath deposition technique. The obtained nanowires were characterized by scanning electron microscope (SEM), X-ray diffraction (XRD), energy dispersive X-ray analysis (EDX) and spectrophotometer. The SEM micrographs revealed the morphology of ZnO... Continue Reading
    ABSTRACT Core-shell oxide thin films of TiO2/MnO, TiO2/CoO, TiO2/NiO and TiO2/CuO have been successfully synthesized and deposited on glass substrates, using the chemical bath deposition [CDB] technique. To ensure uniform coating, surface pre-treatment was carried out by cleaning slides with detergent, deionised water, ammonia acid and rinsed with... Continue Reading
    ABSTRACT Electrochemical capacitors (ECs) or Super capacitors (SCs) are energy saving devices which have excellent properties that include high power density, long cycle life, low temperature sensitivity and low maintenance cost. However, these devices have lower energy densities than conventional batteries. To improve on its energy density, SnO2... Continue Reading
    Call Us
    whatsappWhatsApp Us