DESIGN AND IMPLEMENTATION OF A COMPUTERISED QUALITY CONTROL SYSTEM FOR A MANUFACTURING ORGANISATION (A CASE STUDY OF S.E.D.I ENUGU)

ABSTRACT

The purpose of the study is to computerize quality control system for manufacturing organization (A case study of S.E.D.I Enugu) and to develop a computer package whereby the techniques observed from the manual method can be improved on. It is known fact that the manual method of quality control system in production has been associated with lots in inaccuracy in quality control and this has lead to early break down of parts when in service. The software with developed will facilitate and enhanced the mode and methods of quality control in spare production of S.E.D.I Enugu.

TABLE OF CONTENT

Table page i

Certification ii

Dedication iii

Acknowledgement iv

Abstract v

Organization of the Work vi-vii

Table of Content viii

CHAPTER ONE

Introduction 1

Background of the study 5

Statement of the problem 7

Problems of the study 7

The purpose of the study 8

Scope 9

Aims and Objectives 9

Limitation of the study 10

Definition of term 10

CHAPTER TWO 13

Literature Review 13

CHAPTER THREE 15

Description and Analysis of the existing system 15

Fact funding methods 16

Organization structure 17

Objective of the existing system 18

Justification of the New system 20

CHAPTER FOUR 21

Design of the new system 21

Input  specification and design 21

File design 21

Procedure chart 23

System flowchart 23

System requirement 24

CHAPTER FIVE

Implementation 25

Program design 25

Program Design 25

Psedocodues 29

Test Run

CHAPTER SIX 32

Documentation 32

CHAPTER SEVEN 35

Recommendation 35

References 38